I love the elliptical! 30 minutes a day, working towards an hour. Smooth and quiet enough that I use it almost daily. Hopping on whenever beats the drive to the gym.

Had a piled-up basement setup for years. Squat rack from one place, a sketchy plate-loaded contraption from another, dumbbells everywhere. The G9S replaced all of it. We both train on it now, no swapping setups between sets.

Came back to lifting after a herniated disc kept me out two years. The G9S works because I can change the stack without dropping plates or fighting a heavy bar. PT pushed me toward cable rows. Three sessions a week.

Built it over a Saturday with my kid. The 1" hole spacing lets me dial safety height to the inch. Six months in, the J-cups still sit level and the 1¼" pull-up bar grips without tearing my hands.

Two independent 210-pound stacks let my husband press on one side while I do my rotator cuff work on the other. No queueing. Pulleys swivel to any angle so our teenager sets her pulley height once and stays there.

Twenty-six years of lifting and I've fought enough wobbly benches. Six ladder angles let me match the back pad to the lift instead of settling for close enough. It showed up assembled, so I was pressing the same afternoon. Rated to 450 pounds, and when I'm done it folds to about nine inches and slides behind the door.

Hadn't trained since high school, so I wanted something that didn't need a manual. Five stations, and I move from the press to the lat bar to the low pulley without swapping a single cable. The 145-pound stack gives me room to climb. Three mornings a week now, and sitting at my desk doesn't wreck my lower back the way it used to.

I run small-group sessions out of a converted detached garage. 36 pulley starting positions and 180-degree swivel cover every angle my programs call for. The 310-pound stack means none of my stronger clients top out on cable rows or pressdowns.

Linear ball-bearings through the Smith track, none of the binding you get from bushings under load. The 7-degree bar angle follows the natural press arc instead of forcing shoulders up. 20 lockout points means I rack at the right inch.